Contact Us

An error occurred. Message not sent.
Send
Unika DIY Worktop Jig
DIY-JIG-300x167

Manufactured by Europe’s leading Worktop Jig company,
the Unika DIY Worktop Jig cuts 300, 400, 500, 600, 616 and 620mm worktop widths.

Use with a 12.7mm router cutter and 30mm guide bush. Supplied with 6 nylon pegs.

  • 12mm Hardwearing Compact Laminate Material
  • Guaranteed Never to Warp


Functions

DIY Functions

Requirements:
To operate this Jig, you require a 1600w Router, ½” Tungsten Cutter & 30mm Guide Bush (not supplied).

Download Unika DIY Worktop Jig Instructions

download-pdf
Additional Information
  • This jig can be used to fit 90° corners for worktop widths 300, 400, 500, 600, 616 and 620mm.
  • A 30mm guide bush and a ½” (12.7mm) straight router cutter with a 50mm cutting length are required no other combination of cutter and guide bush will work satisfactorily.
  • It is important that the router is always moved left to right.
  • The cutter must always enter the worktop through the postformed edge, except, of course, for bolt holes. All diagrams have been made showing this set up.
  • Do not plunge the router more than 10mm at a time or use blunt tools.
  • Ensure the guide bush is firmly attached to the router base plate.
  • Ensure that all pegs are pushed fully into the selected holes so that the head of the pegs do not sit proud and so interfere with the action of the router. Note: peg holes that are not counter bored to accept the head of the peg are not meant to be used with the jig that way up.
  • When using the centre slot, always use the side of the slot nearest to you first for the waste removal, with the final pass being performed against the side of the slot furthest from you to finish the cut.
  • When the jig is positioned it must be clamped in place using two “G” clamps.
  • Before cutting check to ensure that all pegs are still tight against the worktop edge (some clamps when tightened can cause the jig to creep out of position).
  • Take care to ensure that the router cutter remains perpendicular when performing all cuts.
  • Please observe all relevant safety requirements for the use of routers.
  • Before starting please take some time to read through the instructions carefully.

Safety First

  • Make sure all cables are clear of the router.
  • Make sure the work piece is correctly supported.
  • Always use protective goggles when using the router.
  • Do not switch router on with blade touching the work.
  • Never remove the router when it is switched on and moving.
  • Make sure there are no obstructions to the path of the router.

 

DURING CUTTING

  • Never try to cut more than 10mm depth on one cut.
  • Do not force the router too fast. This can damage expensive router bits.
  • Never remove the router from the jig whilst it is in motion. Always allow router to stop and switch off before removing.
  • Ensure that the section of the worktop to be routed out is well supported from below.
  • If routing for a long period of time, we advise that ear protection is worn.

 

Troubleshooting

Previous slide Next slide